站点设定

仓库
语言设定
货币设定
资源
视频库
Cx Family Common Mode Chokes
0402CT Low Profile Chip Inductors
XAL7050 High-inductance Shielded Power Inductors
XGL4020 Ultra-low DCR Power Inductors

NA5730-AL Flyback Transformer

for TI TPS23751 and TPS23752 PoE Interface

符合RoHS
  • Developed for Texas Instruments TPS23751 and TPS23752.

立即购买:
计数 单价
1 $4.17
175 $3.57
700 $3.11
1400 $2.63
2800 $2.25
5000 $2.06

对于大批量采购或非库存产品,点击这里请求报价

. 现货,可今天发货.
索取样品:

典型应用

与Texas Instruments TPS23751/2一起使用

输入电压 输出 1 功率 Fsw
Sec Bias
33 V 57 V 5 V , 4.5 A 12 V , 0.02 A 22.5 W 250 kHz

规格

Electrical specifications at 25°C.

零件号 2
(Hover for schematics)
0A时的
电感 (µH) 3
(公差: ±10%)
最小电感
  2.1 A (µH) 4
DCR max (Ω) 5 最大
漏电感
(µH) 6
匝数比 7 隔离
电压 (Vrms) 8
Pri Sec Drive Bias Pri : Sec : Drive : Bias
NA5730-AL_ 62.0 55.8 0.107 0.004 0.060 0.122 2.0 1 : 0.125 : 0.125 : 0.29 1500
注释
  1. Output of the secondary is with the windings connected in parallel. Bias winding output is 12 V, 20 mA. Drive winding output is 5 V, 10 mA.
  2. When ordering, please specify packaging code: e.g. NA5730LD
  3. Inductance is for the primary, measured at 250 kHz, 0.1 Vrms, 0 Adc
  4. Peak primary current drawn at minimum input voltage.
  5. DCR for the primary and the secondary is with windings connected in parallel. DCR measured at 25°C. For other operating temperatures, use this DCR at Temperature calculator.
  6. Leakage inductance is for the primary, measured with the windings connected in parallel and with the secondary windings shorted.
  7. Turns ratio is with the primary windings and the secondary windings connected in parallel.
  8. 1500 Vrms, one minute isolation, primary and bias to secondary and drive.

端子:

  • RoHS-compliant  260°C compatible. Tin-silver-copper over tin over nickel over phos bronze terminations. Other terminations available at additional cost.

包装:

  • D = 13″ machine ready reel. EIA-481 embossed plastic tape (175 parts per full reel). Quantities less than full reel available: in tape (not machine ready) or with leader and trailer ($25 charge).
  • B = Less than full reel. In an effort to simplify our part numbering system, Coilcraft is eliminating the need for multiple packaging codes. When ordering, simply change the last letter of your part number from B to D.
环境
环境:
符合RoHS
环境温度范围:
–40°C to +125°C
储存温度范围:
Component: −40°C to +125°C
Tape and reel packaging: −40°C to +80°C
故障率(FIT)/平均故障间隔时间(MTBF):

原理图

na5730s-(1).gif


Primary windings and secondary
windings to be connected
in parallel on the PC board

物理特性

na5730d-(1).gif


dims_inches_mm-(3).gif

卷装规格

tapereel_pl.gif


 
Parts per reel Reel dimensions (mm) Tape dimensions (mm) Orientation
13" (330 mm) A B C D E W P Po P1 H T
175 330 100 13 50,4 44,4 44 28 4 2 11,9 0,4

一般规格

核心材料:
Ferrite
重量:
11.3 g
包装:
175 per 13″ reel Plastic tape: 44 mm wide, 0.4 mm thick, 28 mm pocket spacing, 11.9 mm pocket depth

焊接/清洗

湿气敏感度等级(MSL):
1 (unlimited floor life at <30°C / 85% relative humidity)
抗焊接热:
Max three 40 second reflows at +260°C, parts cooled to room temperature between cycles
焊接之前,请参阅焊接线艺元件
PCB清洗:
Tested with pure water or alcohol only. More info.