View:
介绍
规格
环境
性能曲线
原理图
物理特性
卷装
焊接/清洗

0805USBF Series

Low Profile Common Mode Chokes

Our 0805USBF Series common mode chokes are great for noise suppression in ultra-high-speed signal lines (USB 3.x, HDMI 2.0, HDBaseT™, DisplayPort, DVI, etc.) and in high-speed differential signal lines (USB 2.0, IEEE1394, and LVDS). They are also suitable for USB-type C specification 1.0 and provide up to 6.0 GHz differential mode 3 dB cutoff frequency and up to 30 dB common mode noise attenuation in the GHz range.

For noise suppression in ultra high speed signal lines: USB 3.x, HDMI 2.0, HDBaseT™,
DisplayPort, DVI, etc.; and in high speed differential signal lines: USB 2.0, IEEE1394, LVDS, etc.
Up to 6.0 GHz differential mode 3 dB cutoff frequency
Up to 30 dB common mode noise attenuation in GHz range
Suitable for USB-type C specification 1.0
AEC-Q200 Grade 1 (−40°C to +125°C)

Refer to Designing Common Mode Filters for design guidance.

立即购买:

零件号

查找我的元件

计数	单价
1	$0.73
200	$0.61
500	$0.44
1000	$0.35
2000	$0.29
4000	$0.27

对于大批量采购或非库存产品，点击这里请求报价。

Tolerance

M = 20%

Termination

R = Matte tin over nickel over silver-palladium-glass frit

Packaging

C = 7" machine-ready reel

. 现货，可今天发货.

索取样品:

零件号

查找我的元件

设计套件:

套件	电感值	价格
C470	39 (10 of each)	$110.00

规格

Electrical specifications at 25°C.

零件号 1	线组数	共模峰值阻抗 (kΩ)	截止频率 (GHz) 2	共模典型衰减 (dB)			最小电感 (nH) 3	Irms (mA) 4	DCR max (Ω) 5	隔离电压 (Vrms) 6
零件号 1	线组数	共模峰值阻抗 (kΩ)	截止频率 (GHz) 2	10 MHz	100 MHz	500 MHz	最小电感 (nH) 3	Irms (mA) 4	DCR max (Ω) 5	隔离电压 (Vrms) 6
0805USBF-421MR_	2	0.14 @ 3.0 GHz	6.6	0.5	4.6	6.9	28	500	0.11	250
0805USBF-901MR_	2	0.30 @ 3.0 GHz	5.8	2.1	9.1	11.8	60	500	0.14	250
0805USBF-172MR_	2	0.52 @ 2.5 GHz	3.3	4	12.8	15.7	101	500	0.22	250
0805USBF-262MR_	2	0.69 @ 2.0 GHz	2.4	5.7	15.4	18.5	165	500	0.24	250
0805USBF-372MR_	2	0.93 @ 1.8 GHz	1.4	5.8	18.1	22.3	241	500	0.27	250
0805USBF-502MR_	2	1.22 @ 1.5 GHz	0.93	11.2	21.6	25.2	315	500	0.32	250
0805USBF-672MR_	2	1.65 @ 1.2 GHz	0.69	11.3	23.3	27.7	434	450	0.37	250
0805USBF-902MR_	2	1.91 @ 1.0 GHz	0.73	12.6	25.4	30	560	350	0.63	250

注释

When ordering, please specify packaging code: e.g. 0805USBF-902MRC
Frequency at which the differential mode attenuation equals 3 dB
Inductance measured at 100 MHz, with windings connected in parallel, using an Agilent/HP 4286A impedance analyzer and a Coilcraft SMD-A fixture.
Irms: Current per winding that causes a 15°C temperature rise from 25°C ambient. This information is for reference only and does not represent absolute maximum ratings.
DCR is specified per winding at 25°C. For other operating temperatures, use this DCR at Temperature calculator.
250 Vrms, 1 minute interwinding isolation (hipot).

端子:

Matte tin over nickel over silver-palladium-glass frit.

包装:

C = 7″ machine-ready reel. EIA-481 embossed plastic tape (2000 parts per full reel). Quantities less than full reel available: in tape (not machine ready) or with leader and trailer ($25 charge).
D = 13″ machine-ready reel. EIA-481 embossed plastic tape (7500 parts per full reel).
B = Less than full reel. In an effort to simplify our part numbering system, Coilcraft is eliminating the need for multiple packaging codes. When ordering, simply change the last letter of your part number from B to C.

环境

环境:

符合RoHS

环境温度范围:

–40°C to +125°C with Irms current.

储存温度范围:

Component: –40°C to +140°C.
Tape and reel packaging: –40°C to +80°C

最高元件温度:

140°C

故障率（FIT）/平均故障间隔时间（MTBF）:

See FIT/MTBF Calculations

性能曲线

Attenuation (Ref: 50 Ohms)

Impedance vs Frequency

原理图

物理特性

卷装规格

Parts per reel		Reel dimensions (mm)					Tape dimensions (mm)						Orientation
7" (178 mm)	13" (330 mm)	A	B	C	D	E	W	P	Po	P1	H	T
2000	7500*	178/330	60/100	13	14,4	8,4	8	4	4	2	1,295	0,23

*Special order

一般规格

核心材料:

Ferrite

重量:

14.7 – 15.5 mg

焊接/清洗

湿气敏感度等级（MSL）:

1 (unlimited floor life at <30°C / 85% relative humidity)

抗焊接热:

Max three 40 second reflows at +260°C, parts cooled to room temperature between cycles

焊接之前，请参阅焊接线艺元件。

PCB清洗:

Tested to MIL-STD-202 Method 215 plus an additional aqueous wash. More info.

0805USBF Series

Low Profile Common Mode Chokes

规格

端子:

包装:

性能曲线

Attenuation (Ref: 50 Ohms)

Impedance vs Frequency

原理图

物理特性

卷装规格

一般规格

焊接/清洗

相关产品系列

0603USB Series

ZE2401 Series

0805USBN Series

仓库

语言设定

货币设定

0805USBF Series

Low Profile Common Mode Chokes

所选配置不可用

规格

端子:

包装:

性能曲线

Attenuation (Ref: 50 Ohms)

Impedance vs Frequency

原理图

物理特性

卷装规格

一般规格

焊接/清洗

相关产品系列

0603USB Series

ZE2401 Series

0805USBN Series

警告